Hey all, this is the first project that I'm uploading to this site. For a bit of background, a while ago I learnt about an open source mesh based text radio project, and I loved the look of it, I bought a couple of boards for it (RAK19007s from the RAK meshtastic starter kit). But they were just raw circuit boards, so I needed a case, I looked up 3D printable ones and found only one. It was pretty good, but only supplied stls (no steps) and didn't allow remixes, this kinda pissed me off, so I decided to build my own, hence this project.

please note this was my first time designing something with the knowledge that I may upload it, so the naming of things in the project are a bit all over the place. I decided to use Onshape as I had begun learning it a bit beforehand and I wanted to upskill a bit